10A/100Apk 2 Output Progressive Voltage Regulator V2 5V+5-6-7.2V / Bypass ElyQ

Description

2 VOLT REG IN 1
Separate outputs :
1 output at 5V (5Amps) dedicated specifically to RX, this guarantees a perfect current avoiding disturbs created by power services.
The other output is related to power and it is subjected to be programmed.
The output can be programmed up to 5V ,6V , 7.2V and in by - pass mode (current reaches directly the final output) and a formidable power capacity to support the ultimate generation high peak servos (from 10A to 100A).Weight about 20 gr
Reduced dimension
50 x 35 x 13 mm MULTI BATTERY TYPE Type of programs for the batteries Lipo, LiFe, Lion, NiCd & NiMh. In the case of Lipo, LiFe and Lion, only 2 cells are foreseen, while NICD batteries can have from 5 to 7 cells.
It is obvious that the possibility of programming batteries is a good enhance for current peak and life of themselves. Precision V - Meter
The user can check precisely the state of the art related to the charging of the batteries through 5 leds. Local and remote switch
Access: normally opened Very low consumption in OFF modality (useful to reduce the problem of discharging, either if the user forgets the battery switched on or the limit is over due when not in use for a long time). Indication of the programmed power tension through 3 leds.No need to use step down circuits Avoiding RF filters. The layout, the circuital typology and the fact that RX are supplied separately, avoid the need of further filters on the power alimentation circuit.
The programmability management is allowed trough a microprocessor.